Create Power Supply; Insert Batteries; Connect The Power Supply Unit (Optional) - Seca 703 Mode D'emploi Et Garantie

4.2 Create power supply

Insert batteries

Connect the power
supply unit (optional)
44 •
Power is supplied to the scales either using batteries or
with a power supply unit available as an accessory.
You need 6 batteries, type AA (Mignon), 1.5 V (included
in scope of supply).
1. Press on latch of battery compartment.
2. Move down lid of battery compartment.
3. Remove battery holder.
4. Insert batteries in holder.
NOTE:
Observe correct polarity of batteries (markings
on battery holder). Should the display read
bAtt
, you have inserted one of the batteries
incorrectly or they are flat.
5. Replace the holder with the batteries in the battery
compartment.
6. Close the battery compartment.
The scales can be operated with a power supply unit
available as an accessory.
WARNING!
Personal injury and damage to device if incor-
rect power supply unit is used
The voltage provided by standard power supply
units may be higher than their indicated rating.
This may cause the scales to overheat, catch
fire, melt or short-circuit.
– Only use genuine seca plug-in power supply
units with 9V or a controlled 12 V output
voltage.
1. Insert the power plug necessary for your power
supply in the power supply unit.
2. Insert the connector plug of the power supply unit
in the connecting socket of the scales.
3. Plug the power supply unit into a mains socket.