RHINO BLX Manuel D'utilisation page 48

• Press button 6 to return to a saved track (see section 3.5),
follow it and switch to Navigation mode. After selecting the
track number, press "Con rm" (3).
• Now select the path to the start/end along the desired track
and your Rhino BLX will navigate back to the start/end of that
track.
• When the destination is reached, the motor goes into "Anchor"
mode.
• The display then shows the spot number, directional angle
(BRG) and distance again.
Note: You can navigate to or along a track or spot while your
Rhino BLX GPS is in "Travel" mode (section 3.4).
• Your Rhino BLX follows a recorded track from any position
from which you start the track. The remote screen function
area shows the remaining length of the track. Each of the 16
storable tracks can be up to 5 km long.
NOTE: You can stop moving along the selected track at any time
by pressing the Navigation button to exit Navigation mode.
You can also leave the selected track and then switch to Manu-
Start
3.7 Arrival mode
Arrival mode allows the user to determine the nal setting of
the moto when the destination has been reached in Navigation
mode. The factory setting is Anchor mode.
• Press the red button (3) to activate the main menu.
• To select the desired mode, scroll down in the menu with
the blue arrow key (1,2) to "Arrival mode" and press button 3
("Con rm") again. You can select from:
8
Go to the
start
Navigation-Track
Track 4
DISTO1.6km
Track 5
BRG 120º
Back Confirm
al mode or Anchor mode, e.g. when ghting or landing a sh.
• To return to your track, press "Navigate" again, select the track
number, choose "Con rm", and your Rhino BLX GPS motor will
take you back to the nearest point on your track and continue
navigation.
• Again, make sure that there are no hazards on the direct route
between your boat and the track. Maintain a safe speed and
always pay attention to the ambient conditions.
Go to the
end
Tracking
Point
End
Anchor mode (see section 3.2)
Manual mode (see section 3.1)
Motor o = propeller is switched o
• Con rm the desired mode by pressing the red button (3).
• The motor now performs the desired function when the
target is reached.