RHINO BLX Manuel D'utilisation page 42

Rhino BLX GPS Motor User Guide (remote control):
1. GENERAL
Introduction ......................................................................... 1.1
General start-up instructions ............................................... 1.2
2. SYSTEM OVERVIEW AND SETUP
Layout of the remote control and LCD display ...................... 2.1
Switching on the motor and remote control ......................... 2.2
Calibration ............................................................................ 2.3
General con guration ........................................................... 2.4
3. ADJUSTABLE MODES
Manual mode ........................................................................ 3.1
Anchor mode ........................................................................ 3.2
Pilot mode ............................................................................ 3.3
Travel mode ("cruise control") .............................................. 3.4
Track recording ..................................................................... 3.5
Navigation mode ................................................................. 3.6
Arrival mode (optional setting when reaching
the destination) .....................................................................3.7
1. GENERAL
1.1 Introduction
Thank you for choosing the Rhino BLX GPS motor from Zebco
Europe GmbH.
This manual has been specially designed to guide you through
the functions of the GPS remote control unit step by step.
1.2 General start-up instructions
• Make sure your Rhino BLX GPS motor is securely attached to
your boat.
• Make sure that the 12V deep discharge battery is fully
charged. The GPS motor is not intended for use with a starter
battery for cars/trucks.
• Check the battery cable for damage.
• Check the battery terminals for corrosion or contamination.
• Makes sure that the remote control is su ciently charged.
2
12.3 V
(The battery indicator is located in the upper right corner of
the active screen.)
• Connect your Rhino BLX GPS motor to a deep-discharge
capable 12-volt marine battery.
• Put the motor in travel position and secure the locking device
so that the lever is in the upper position.
NOTE: Your Rhino BLX motor is equipped with a sensor that
turns o the motor when it is folded up.
2. SYSTEM OVERVIEW AND SETUP
2.1 Layout of the remote control and LCD display
H
G
12.2 V
2
F
Lock
A
Battery status
B Actual speed
C
Propeller status
D
Operating mode
A
00.0
B
KPH
C
Target
00.3KPH
D
Setting
E
E
Menu selection area
F Speed setting
G GPS signal strength
Status of wireless link to motor
H