RHINO BLX Manuel D'utilisation page 44

2.3 Calibration
• The remote control may now prompt you to calibrate the
steering.
Press the RIGHT or LEFT button (9,10) to register the steering.
Calibration takes about 10 seconds.
9
2.4 General con guration
• Press the red button again to activate the main menu. Use
the blue UP/DOWN buttons (1,2) to scroll through the setup
menu.
• To con gure the boat size, scroll down in the menu with the
blue arrow key (1,2) to "Boat Size".
• Con rm the boat size by pressing the red button (3). You can
select from:
Small boat ("little") = shorter than 3m
Medium-sized boat ("medium") = 3m-4m
Large boat ("large") = 4m +
• This helps your Rhino BLX GPS motor to deliver the right
amount of power to the propeller at all times.
• Return to the Settings menu with the left blue button (5).
5
• Scroll to "Unit" and select "metric" or "imperial". To con rm,
press the red button (3).
• The default setting is "metric". Press the left blue button (5) to
return to the main menu and continue.
• In the "Backlight" menu, adjust the brightness and auto-o
feature.
• Please note: The longer and brighter the display is illuminated,
the shorter the battery life of the remote control.
4
3. ADJUSTABLE MODES
3.1 Manual mode
• In this mode, the mode information area is empty.
0
Lock
• The status LED of the base station is lit up in GREEN.
10
The motor can now be operated manually with the remote
control.
• The buttons 7, 8, 9, 10 and 11 control the propeller, speed and
steering. You can now use these buttons to operate the motor
in manual mode.
• The default setting for the remote control at startup is zero.
The propeller is stopped. Use the middle button 8 (propeller
symbol) to activate and deactivate the propeller.
• The grey UP/DOWN arrows (buttons 7,11) increase or
decrease the propeller power from zero to level 10. The device
acknowledges each press of a button with a short signal tone
from the base unit.
• The LEFT/RIGHT buttons (9,10) on the remote control can be
pressed for a maximum of 7 seconds. Press the button once
more to reactivate.
Likewise, a tone is emitted when the propeller is stopped/star-
ted by pressing button 8.
• Please press evenly to ensure smooth operation.
Note: When the propeller is switched on again via button 8, the
last speed setting is activated!
12.3 V
00.0
KPH
Setting
7 8 9 10 11