Putting Into Operation; Switching On The Appliance; Control; Setting The Child Lock Function - V-ZUG Jumbo 60i Mode D'emploi

Putting into operation

4 Putting into operation

4.1 Switching on the appliance

Switch on the appliance approx. 2 hours before loading for the
first time.*
u Open the door.
Fig. 2 (1) .
u Press On/Off button
w The temperature display indicates the current temperature.
w The interior light is on when the door is open.
w If "DEMO" is displayed, demo mode is activated. Please
contact the after sales service.

5 Control

5.1 Setting the child lock function

u To activate setting mode: Press and hold the SuperCool
Fig. 2 (2) for approx. 5 s.
button
w The display indicates .
c
When is shown on the display:
c1
u To switch on the child-proof lock, press the
Fig. 2 (2) briefly.
SuperCool button
w The child lock symbol
display.
When is shown on the display:
c0
u To switch off the child-proof lock, press the SuperCool
Fig. 2 (2) briefly.
button
w The child lock symbol Fig. 2 (8) goes out.
display.
u To deactivate the set-up mode: press On/Off button
Fig. 2 (1) .
-or-
u Wait for 5 minutes.
w The temperature is indicated again in the temperature
display.

5.2 Refrigerator compartment

Different temperature ranges are set in the fridge compartment
because of the natural air circulation. It is coldest directly above
the plate dividing the FreshControl area and the rear wall. The
warmest area is at the top front and in the door.
5.2.1 Refrigerating food
Note
The energy consumption increases and the cooling perform-
ance decreases if the ventilation is inadequate.
u Always keep the air slits of the fan free.
u Place butter and preserves in the top area and in the door.
(see 1 Appliance at a glance)
u Use reuseable plastic, metal, aluminium, glass containers
and foil wrap to store food.
u Always store raw meat and fish in clean, sealed containers
on the bottom shelf of the refrigerator, to prevent them
coming into contact with or dripping onto other foods.
u Foods that easily absorb or give off smell or taste, as well as
liquids, should be stored in sealed containers or covered.
u Use the front area of the base shelf only to temporarily set
down refrigerated foods, for example while rearranging or
sorting the contents. Remember not to leave refrigerated
foods here as they could shift to the back or tip over when
you close the door.
40
Fig. 2 (8) shines.
flashes in the
c
flashes in the
c
u Do not pack foods too closely together, as the air needs to
circulate.
5.2.2 Setting the temperature
The temperature depends on the following factors:
the frequency of opening the door
-
- how long the door is open for
- the room temperature of the installation location
the type, temperature and quantity of the food
-
The temperature can be set from 9 °C to 3 °C, the recom-
mended temperature is 5 °C.
An average temperature of about –18 °C is reached in the
freezer compartment.*
Note
If the temperature is to be colder than 3 °C:
u set the cooling temperature to 3 °C.
u Set the FreshControl temperature to a value between
(slightly colder) and (coldest)
b1
u For a higher temperature setting: press Up button
u For a lower temperature setting: press Down button
Fig. 2 (4) .
w When the button is pressed the first time, the previously set
value is indicated, flashing, in the temperature display.
u To change the temperature in 1 °C steps: briefly press the
button.
u To change the temperature continuously: hold down the
button.
w The value is displayed flashing during the setting operation.
w The actual temperature is displayed about 5 s after the last
press of a button. The temperature slowly adjusts to the new
value.
5.2.3 QuickCool
QuickCool selects the lowest cooling temperature. This option
is for very low temperatures:
- In the fridge compartment
In the freezer compartment*
-
Use QuickCool to quickly cool large quantities of food.
To freeze food, activate QuickCool when you place the goods
in the appliance.*
Quick Cool uses slightly more energy.
Activating QuickCool
u Briefly press the Quick Cool button
Fig. 2 (9) symbol lights up on the display.
w The QuickCool
w The cooling temperature drops to the lowest setting.
w The freezing temperature drops to the lowest setting.*
w QuickCool is on.
w QuickCool turns off automatically. The appliance continues
in energy-saving Normal mode.
SwitchingQuick Cool off ahead of schedule
u Briefly press the Quick Cool button
Fig. 2 (9) symbol dims on the display.
w The Quick Cool
w Quick Cool is off.
5.2.4 Tray
Shifting or removing the trays
The trays are prevented from being pulled out accidentally by
pull out stops.
* Depending on model and options
b4
Fig. 2 (3) .
Fig. 2 (2) .
Fig. 2 (2) .