Description Of Components; Preparation; Opening Out The Handle (Illustration A1 + E1 + B1 ); Handle Starter Assembly (Illustration D + L1 ) - Sabo 40-SPIRIT Livret D'entretien

6

DESCRIPTION OF COMPONENTS

1 Safety control bracket for the engine brake
2 Handle (carrying handle rear) with push button for adjusting the height
3 Oil filling nozzle with dipstick
4 Cutting height indicator
5 Carrying handle front
6 Spark plug
7 Primer pump
8 Tank cap
9 Air filter
10 Ejection flap
11 Starter cable grip
7

PREPARATION

The following parts are included in the packaging for assembly of the mower:
• Mower with preassembled handle
• Collecting bag, collecting bag frame, chute
• Tool bag with the following contents:
– Operator's manual with Declaration of Conformity
– Warranty conditions and Warranty card
– Various fixing parts.
In the unlikely event of a missing part, please contact your dealer.

Opening out the handle (Illustration A1 + E1 + B1 )

– Pull the folded-up Z-shaped guide spar apart and upward A1 .
– When upper and lower handle are aligned tighten the two wing-nuts by hand E1 .
– Push both ends of the bottom part of the handle with the toothed plastic adapters backwards until they click into the
GB
toothed recess on the mower housing B1 .
In this way, three different handle heights can be set.
– Tighten the two wing-nuts on both sides by hand B1 .
– Insert the cable on the left hand side into the cable guide. This is to prevent the cable from being trapped when folding
the handle E1 .
– Attach the Bowden cable to the bottom section of the guide spar with the aid of cable ties from the tool bag.
CAUTION
When you activate the bar height adjustment, when loosening the wing nuts B1 used to secure the bar bottom to
the housing (only loosen sufficiently to ensure that the bar can be moved freely) and snapping the toothed plastic
adaptations from the cut-out on the housing, it is possible that unintentional upsetting of the bar may occur. In
addition, this may result in crushed points between the bar bottom and the housing. This may result in a risk of
injury!

Handle starter assembly (Illustration D + L1 )

– Remove the starter handle mounting (1), profile washers (2) and nuts (3) from the tool bag.
– Push one washer (2) onto the starter handle mounting (1).
– Then insert the starter handle mounting (1), together with the washer (2), from above into the drillhole on the right side
of the handle. From below, attach the second washer (2) and the nut (3) and tighten L1 .
– The safety control bracket (5) on the upper handle (6) must be folded down before the starter cable can be suspended
D .
– Pull out the starter cable (4) slowly and fit in the starter handle mount (1) with a twist motion L1 .
8