Important - LENCO DAR-050 Mode D'emploi

LOCATION OF CONTROL
1) LCD display
2) Standby LED
3) Play/pause /Scan button
4) Stop /Enter button
5) On/standby button
6) Open/close button
7) Function button
8) 3.5mm headphone jack
9) Aux in jack
10) Remote sensor
11) CD tray
12) Skip/Tuning down
13) Skip/tuning up
14) Volume up button
15) Volume down button
16) Menu/Mem/clock-adjust button
17) USB socket
18) FM antenna
19) Line out socket
20) DC jack
Caution:
Usage of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
This unit should not be adjusted or repaired by anyone except qualified service personnel.

Important:

Since movement of the CD mechanism and the sensitive circuitry may cause interference to the
radio tuner nearby, switch this unit off while operating other radio devices.
Due to the complexity of MCU control, please un-plug the main power supply of the unit if
found the unit hang up during operation!
This is not a malfunction of the system!
Precautions for use
Installation
 Unpack all parts and remove protective material.
 Do not connect the unit to the mains before checking the main voltage and before all other
connections have been made.
 Do not cover any vents and make sure that there is a space of several centimeters around
the unit for ventilation.
Connection
1. Connect the DC plug of the included AC/DC adaptor to DC jack (20) then the AC/DC adaptor
connect to the AC outlet.
2. When you first plug the unit into the mains, the unit will go into standby mode. The Standby
LED (2) will light up
button
button
5