LENCO DAR-050 Mode D'emploi page 7

Skip up (13) again to select FM stereo, then press Enter button (4) to confirm. When
stereo signals are weak and noisy. It is preferable to change the FM mode by same
procedure.
Hints for best reception:-
FM: the receiver has rod antenna (18) hanging at the rear cabinet. This antenna should be totally
unraveled and extended for best reception.
Radio data system (RDS) (On remote control only)
This is the features to display the information which released from the radio broadcast and will
showed on LCD display step by step as below by pressing the Play mode/info button continuously
(on remote control).
Radio text  program type  frequency  mono/stereo  time  date
Digital audio broadcasting (DAB) radio
1. Set the unit to DAB mode by press Function button (7).
2. Press the Play/pause
one time. Press Skip down
channel then press "Stop/Enter" button (10) to confirm the selected channel.
3. Press the Play mode/info button (on remote control) continuously to check the below info
released by DAB.
signal strength  program type  Group name  frequency  signal error  transfer rate
 time  date
4. Adjust volume knob (14/15) for the desired volume level.
Dynamic range control
This apparatus provide three dynamic range mode to match different program type in DAB mode.
1. In DAB mode, press "Menu/Mem/clk-adj" button (16) to enter the "Menu", then press Skip
down (12) or Skip up
2. Press "Stop/Enter" button (4) to enter the "DRC" setting, then press Skip down
(13) button to select "DRC high/low/off" mode. Then press "Stop/Enter" button
Skip up
(4) to confirm the setting.
3. In any state press "Menu/Mem/clk-adj" button (16) to quit the setting mode
Language setting
This apparatus provide 4 language for FM/DAB operation display.
1. In DAB/FM mode, press "Menu/Mem/clk-adj" button (16) to enter the "Menu", then press
Skip down (12) or Skip up
2. Press "Stop/Enter" button (4) to enter the "System" setting, then press Skip down
(13) button to select "Language" then press "Stop/Enter" button to enter
Skip up
language mode, then press Skip down
desired language between English/French/German/Italian. Then press "Stop/Enter" button (4)
to confirm the setting.
3. In any state press "Menu/Mem/clk-adj" button (16) to quit the setting mode
Preset stations
You can store up to total of 20 radio stations in the memory (10-FM/10-DAB).
1. Set to FM/DAB mode.
2. Turn to the desired radio station by "manual" or "auto" tuning method.
3. Press and hold the "Mem/clk-adj" button (16) to enable memory state.
/Scan button (3) once, unit will start to full scan from range 11b-12d
(12) or Skip up
(13) button to select "DRC".
(13) button to select "System".
(12) or Skip up
7
(13) button to select your desired DAB
(13) button to select your
(12) or
(12) or