Battery Replacement - LENCO DAR-050 Mode D'emploi

20. The ventilation should not be impeded by covering the ventilation opening with items
such as newspaper, table-cloths, curtain etc;
21. No naked flame sources such as lighted candles should be placed on the apparatus;
22. Attention should be drawn to the environmental aspects of battery disposal;
23. The use of apparatus in moderate climates

BATTERY REPLACEMENT

The battery compartment is located on the back of the remote control.
1. Remove the battery compartment door by pressing in on the tab and lifting it off.
2. Insert two (2) AAA size batteries (not included) into the battery compartment following the
polarity markings inside the battery compartment.
3. Replace the battery compartment door.
Battery Precautions
 Replacement of batteries must be done by an adult.
 Do not mix old and new batteries.
 Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
 The supply terminals are not to be short-circuited.
 Non-rechargeable batteries are not to be recharged.
 Exhausted batteries are to be removed.
 Only batteries of the equivalent type are to be used.
 Batteries are to be inserted with the correct polarity.
 Dispose of batteries properly. Do not dispose of batteries in fire. The batteries may
explode or leak.
CLASS I LASER
PRODUCT
4