Faults; Accessories - Kärcher BD 50/60 C Ep Classic Mode D'emploi

DANGER
Risk of injury! Set the programme selector
switch to "OFF" and disconnect the mains
plug prior to performing any work on the de-
vice.
 Drain and dispose of the dirt water and
the residual fresh water.
Failure Correction
Appliance cannot be Turn the program selection switch to the desired programme.
started
Operate the safety switch.
Insert the mains plug into the socket.
Is the indicator light voltage supply on?
Insufficient water quan- Check fresh water level, refill tank if necessary.
tity
Increase the water volume on the regulating knob for water volume.
Clean sieve.
Insufficient vacuum per- Clean the seals between waste water tank and cover and check for tightness, replace if required.
formance
Check the seals between waste water tank and fresh water tank for damage, replace if necessary.
Wastewater reservoir is full; shut off the appliance and empty the wastewater reservoir
Clean the fluff filter.
Clean the vacuum lips on the vacuum bar, replace if required
Check if the cover on the dirt water discharge hose is closed
Check the setting of the vacuum bar.
Check suction hose for blockages; clean if required.
Check the suction hose for tightness; replace if required.
Insufficient cleaning re- Check the brushes for wear, replace if required.
sult
Suction turbine is run- Clean the swimmer.
ning rough
Brush does not turn Check if foreign objects block the brush; remove foreign object if required.
Release the safety switch.
Wait for a while.
Operate the safety switch.
Vibrations during clean- You might need to use a softer brush.
ing
In case of faults that cannot be remedied using the table below please contact the customer service.
Description
Disk brush, red (medium, standard)
Disk brush, natural (white)
Disk brush, black (hard)
Driver plate pad
Pad, red (medium soft)
Pad, green (medium hard)
Pad, black (hard)
Pad, beige (light grain)
Pad, beige (natural hair proportion)
Suction bar, 850 mm, straight
Suction bar, 850 mm, bent
Set homebase box
Mop holder
14

Faults

Accessories

Part no.: Description
4.905-026.0 For the use with all common cleaning tasks.
4.905-027.0 Made of natural fibres for spot cleaning and polishing.
4.905-029.0 For heavy soiling and for deep cleaning. For robust floorings only.
4.762-534.0 For cleaning with pads. With quick change coupling and center lock.
6.369-079.0 For cleaning and cleanering of all floors.
6.369-078.0 For cleaning heavily soiled floors and for deep cleaning.
6.369-077.0 With stubborn soiling and for deep cleaning.
6.369-468.0 For polishing and refreshing of hard and flexible floorings.
6.371-146.0
4.777-401.0
4.777-411.0
4.035-406.0
9.753-023.0
6
-
EN