Frost Protection - Kärcher BD 50/60 C Ep Classic Mode D'emploi

Replace or turn vacuum lips
1 Wear indicator
2 Vacuum lip
The vacuum lips must be replaced or re-
versed if they are worn down to the wear in-
dicator.
 Remove the vacuum bar.
 Unscrew the star grips.
 Remove the plastic parts.
 Remove the vacuum lips.
 Insert new or reversed vacuum lips.
 Insert the plastic parts.
 Screw in and tighten the star grips.
Replacing the disk brushes
 Push down the device holding the push
handle so that the cleaning head is
raised.
 Press the pedal for changing the brush-
es downward beyond its resistance.
 Pull the device towards the back so that
the disc brush becomes accessible.
 Place a new disc brush on the floor in
front of the device.
 Drive the device with the raised clean-
ing head over the new disc brush and
lower the cleaning head.
The brush locks into the drive.
Removing the waste water tank
 Drain off dirt water.
 Lift up the waste water tank and put it
aside.
Maintenance contract
To ensure a reliable operation of the appli-
ance maintenance contracts can be con-
cluded with the competent Kärcher sales
office.

Frost protection

In case of danger of frost:
 Empty the fresh and waste water tank.
 Store the appliance in a frost-protected
room.
5
-
EN 13