Set The Alarm Timer; General Operation; Standby/On - SOUNDMASTER UR411 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28

Set the Alarm Timer

Before setting the alarms ensure the time shown on the clock is correct.
1. Press and hold the ALARM (1 or 2) buttons in standby mode for a few seconds and the hour digits will
flash. Press the
p
wish to woken.
2. Press the ALARM (1 or 2) button and the minutes digits will flash. Press the
remote control or the / buttons on main unit to set the minutes.
3. Press the ALARM (1 or 2) button again and press the
buttons on main unit to select an alarm sound. You can select either FM or DAB or beeps (BUZZER).
4. Press the ALARM (1 or 2) button again and the flashing volume level will be displayed. Press the
buttons on the remote control or the / buttons on main unit to select the volume level.
Note: Set the volume to at least level 5. Please add to ensure alarm can be heard.
Activate and Deactivate the Alarm Timer
• Press the ALARM 1 or ALARM 2 button to activate the alarm.
-
The alarms are active when
-
To deactivate the alarms, press the ALARM (1 or 2) button . The
the display on the front of the unit.
Repeat Alarm
You can press to adjust the interval to repeat alarm. When the alarm rings, press the SNOOZE/DIMMER
button on main unit, the alarm repeats ringing 9 minutes later.
Stop Alarm Ring
When the alarm rings, press the corresponding ALARM (1 or 2) button. The alarm stops but the alarm
settings remain.
View the Alarm Settings
Press the ALARM 1 or ALARM 2 buttons to view the alarm settings.

General Operation

Standby/ON

When you first connect the unit to the mains socket, the unit will be in STANDBY mode.
• Press the ON/OFF/SOURCE button on the main unit or the
the main unit ON.
• Press and hold the ON/OFF/SOURCE button on the main unit or press the
control to switch the main unit back to Standby mode.
• Disconnect the mains plug from the mains socket if you want to switch the unit off completely.
Note: If there is no signal under the LINE IN and BLUETOOTH mode, the unit will automatically switch
off within 15 minutes.
/
buttons on the remote control or the / buttons on main unit to set the hour you
q
or
/
buttons on the remote control or the /
p
q
both are shown in the display on the front of the unit.
9
/
buttons on the
p
q
and/or
will disappear from
button on the remote control to switch
button on the remote
/
p
q

Publicité

Table des Matières
loading

Table des Matières