Radio Operation; Auto Scan And Save Preset Station; Tuning In A Station; Presetting Stations Manually - SOUNDMASTER UR411 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
-
To skip to a track, press the / buttons.

Radio Operation

Auto Scan and Save Preset Station

1 Press the ON/OFF/SOURCE button on the unit or press the SOURCE button on the remote control
repeatedly to select FM mode.
2 Press and hold the
activate automatic programming. All available stations are programmed in the order of waveband
reception strength.
-
The first programmed radio station is played automatically.
3 To select and listen to a saved radio station, press the
radio station.

Tuning in a Station

• Tune in radio stations automatically
-
Press and hold the / buttons, the frequency changes down or up automatically until a station is
found.
Note: The search may not stop at a station with a very weak signal.
• Tune in radio stations manually
-
Press the / buttons repeatedly until you find the station you want.
Note: If reception is still poor, try to adjust the position of the aerial or try to move the radio to another
location.

Presetting Stations Manually

You can store up to 20 of your favourite stations to the memory. This will enable you to access your
favourite stations quickly and easily.
1 Tune in the desired station, then press the PROG button.
2 Press the
/
buttons to select the preset number.
p
q
3 Press the PROG button to store the station.
4 Repeat above steps 1 to 3 for each station you want to store in memory with a preset number.
button on the main unit or press the SCAN button on the remote control to
or
buttons to skip to the previous/next preset
p
q
12

Publicité

Table des Matières
loading

Table des Matières