Bosch 24618 Consignes De Fonctionnement/Sécurité page 10

BM 2610034434 09-15_24618 25618 IWH181 9/8/15 9:27 AM Page 10
LEVER & TRIGGER LOCK
After tool use, lock trigger in "OFF" position to
help prevent accidental starts
and accidental discharge.
WARNING
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 4). This lever was designed
for changing rotation of the bit, and for locking
the trigger in an "OFF" position.
For forward rotation, (with chuck pointed
away from you) move the lever to the far left.
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to
the center off position.
Do not change direction of rotation until
the tool comes to a
complete stop. Shifting
CAUTION
during rotation of the chuck can cause
damage to the tool.
BUILT IN WORK LIGHT
Your tool is also equipped with a light that turns
on automatically when the switch is activated,
for better visibility when driving (Fig. 1).
BIT STORAGE AREA
(Model 25618 only)
Your tool is equipped with a bit and storage
area that is conveniently located in the handle
base where it is always handy and unlikely to
get lost or misplaced (Fig. 5).
BELT CLIP (Optional Accessory)
When the tool is attached to
the belt, position yourself to
WARNING
avoid entanglement with surrounding objects.
Unexpected entanglement could cause the tool
to fall resulting in injury to the operator or
bystanders.
The optional belt clip accessory will allow you to
conveniently attach your tool to your belt. This
feature will allow you to have both hands free
when climbing a ladder or moving to another
work area.
FORWARD/REVERSING
LEVER & TRIGGER LOCK
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use (Fig.5).
To use clip, turn tool upside down and attach
to your belt.
-10-
FIG. 4
FIG. 5
BIT AND BIT
STORAGE
AREA
BELT CLIP
(Optional Accessory)