Yamaha WR250F Manuel D'atelier page 524

Å
ı
FRONT BRAKE AND REAR BRAKE
5 - 27
2. Air bleed:
Brake system
G
Refer to "BRAKE
BLEEDING" section in the CHAPTER
3.
3. Inspect:
Brake fluid level
G
Fluid at lower level → Fill up.
Refer to "BRAKE
INSPECTION" section in the CHAP-
TER 3.
4. Install:
[Front]
Diaphragm
G
Brake master cylinder cap 1
G
Screw (brake master cylinder cap) 2
G
2 Nm (0.2 m · kg, 1.4 ft · lb)
[Rear]
Diaphragm
G
Reservoir tank cap 1
G
Screw (reservoir tank cap) 2
G
2 Nm (0.2 m · kg, 1.4 ft · lb)
Brake master cylinder guard
G
10 Nm (1.0 m · kg, 7.2 ft · lb)
CAUTION:
After installation, while pulling the brake
lever in or pushing down on the brake
pedal, check whether there is any brake
fluid leaking where the union bolts are
installed respectively at the brake master
cylinder and brake caliper.
Å Front
ı Rear
5. Install: (rear brake only)
Protector 1
G
Bolt (protector) 2
G
7 Nm (0.7 m · kg, 5.1 ft · lb)
CHAS
SYSTEM AIR
FLUID LEVEL