Yamaha WR250F Manuel D'atelier page 200

ENGINE OIL REPLACEMENT
7. If the oil filter is to be replaced during this
oil change, remove the following parts
and reinstall them.
Replacement steps:
Remove the oil filter element cover 1 and
G
oil filter element 2.
Check the O-rings 3, if cracked or dam-
G
aged, replace them with a new one.
Install the oil filter element and oil filter ele-
G
ment cover.
8. Install:
G
G
G
G
G
G
9. Install:
G
G
G
G
10. Fill:
G
11. Check:
G
12. Install:
G
13. Check:
G
3 - 17
Oil filter element cover:
10 Nm (1.0 m • kg, 7.2 ft • lb)
Copper washer 1
Oil strainer (frame) 2
90 Nm (9.0 m · kg, 65 ft · lb)
Oil hose 3
Bolt (oil hose) 4
10 Nm (1.0 m · kg, 7.2 ft · lb)
Oil hose clamp 5
2 Nm (0.2 m · kg, 1.4 ft · lb)
Lower engine bracket
10 Nm (1.0 m · kg, 7.2 ft · lb)
Copper washer
Oil filter element drain bolt
10 Nm (1.0 m · kg, 7.2 ft · lb)
Crankcase oil drain bolt
20 Nm (2.0 m · kg, 14 ft · lb)
Frame oil drain bolt
23 Nm (2.3 m · kg, 17 ft · lb)
Engine oil
Oil quantity:
Total amount:
1.7 L (1.50 Imp qt, 1.80 US qt)
Periodic oil change:
1.5 L (1.32 Imp qt, 1.59 US qt)
With oil filter replacement:
1.6 L (1.41 Imp qt, 1.69 US qt)
Oil leakage
Oil tank cap
Engine oil level
INSP
ADJ