Yamaha WR250F Manuel D'atelier page 244

FRONT FORK COMPRESSION DAMPING FORCE
ADJUSTMENT
EC36J001
FRONT FORK COMPRESSION DAMPING
FORCE ADJUSTMENT
1. Remove:
Rubber cap
G
2. Adjust:
Compression damping force
G
By turning the adjuster 1.
Stiffer a → Increase the compression
damping force. (Turn the adjuster 1
in.)
Softer b → Decrease the compression
damping force. (Turn the adjuster 1
out.)
Extent of adjustment
Maximum
Fully turned in
position
STANDARD POSITION:
G
This is the position which is back by the spe-
cific number of clicks from the fully turned-in
position.
Standard position:
14 clicks out
* 15 clicks out
* For AUS, NZ and ZA
CAUTION:
Do not force the adjuster past the minimum
or maximum extent of adjustment. The
adjuster may be damaged.
WARNING
Always adjust each front fork to the same
setting. Uneven adjustment can cause poor
handling and loss of stability.
3. Install:
Rubber cap
G
3 - 38
INSP
ADJ
Minimum
20 clicks out
(from maximum
position)