Yamaha WR250F Manuel D'atelier page 430

CDI MAGNETO
EC4L5000
ASSEMBLY AND INSTALLATION
CDI magneto
1. Install:
Stator 1
G
Screw (stator) 2
G
NOTE:
Apply the sealant on the grommet of the CDI
G
magneto lead.
Tighten the screws using the T30 bit.
G
Quick gasket
ACC-QUICK-GS-KT
YAMAHA Bond No. 1215:
90890-85505
2. Install:
Woodruff key 1
G
Rotor 2
G
NOTE:
Clean the tapered portions of the crankshaft
G
and rotor.
When installing the woodruff key, make sure
G
that its flat surface a is in parallel with the
crankshaft center line b.
When installing the rotor, align the keyway c
G
of the rotor with the woodruff key.
3. Install:
Washer 1
G
Nut (rotor) 2
G
Use the rotor holding tool 3.
Rotor holding tool:
YU-1235/90890-01235
4 - 81
ENG
10 Nm (1.0 m · kg, 7.2 ft · lb)
®
:
48 Nm (4.8 m · kg, 35 ft · lb)