Yamaha WR250F Manuel D'atelier page 156

1 Brake hose
2 Brake hose holder
3 Brake master cylinder
ı 2
CABLE ROUTING DIAGRAM
Ç
Î
3
A
1
Å
Å Install the brake hose to the brake caliper with the
paint on the pipe facing the brake caliper and with
the pipe contacting the brake caliper projection.
ı Pass the brake hose into the brake hose holders.
Ç If the brake hose contacts the spring (rear shock
absorber), correct its twist.
Î Install the brake hose so that its pipe portion
directs as shown and lightly touches the projection
on the brake master cylinder.
2
1
2 - 23
SPEC
A
3