Publicité
Les langues disponibles
Les langues disponibles
p) Disconnect appliance. Disconnect the
appliance from the power supply when not
in use, before servicing, when changing
accessories such as blades, and the like.
q) Store idle appliances indoors. When not
in use, appliances should be stored indoors
in dry, and high or locked-up place, out of
reach of children.
r) Maintain appliance with care. Keep
cutting edge sharp and clean for best
performance and to reduce the risk of
injury. Follow instructions for lubricating
and changing accessories. Inspect
appliance cord periodically, and if
damaged, have it repaired by an authorized
service facility. Inspect extension cords
periodically and replace if damaged. Keep
handles dry, clean, and free from oil and
grease.
s) Check damaged parts. Before further use
of the appliance, a guard or other part that
is damaged should be carefully checked
to determine that it will operate properly
and perform its intended function. Check
for alignment of moving parts, binding of
moving parts, breakage of parts, mounting,
and any other condition that may affect
its operation. A guard or other part that is
damaged should be properly repaired or
replaced by an authorized service center
unless indicated elsewhere in this manual.
SAVE THESE INSTRUCTIONS
Table 1 Minimum gauge for extension
cords
Volts
120V
240V
Ampere Rating
More than Not
more than
0-6
6-10
10-12
12-16
Figure 1 Method of securing extension
cord
5.5A Electric Grass Trimmer/Edger
Total length of cord in feet
25
50
100
150
50
100
200
300
AWG
18
16
16
18
16
14
16
16
14
Not
14
12
recommended
CORD
SET
3. EDGER-TRIMMERS
a) Keep guards in place and in working
order.
b) Keep blades sharp.
c) Keep hands and feet away from
cutting area.
4. Save these instructions. Refer to them
frequently and use them to instruct others
who may use this tool. If someone borrows
this tool, make sure they have these
instructions.
ADDITIONAL SAFETY
RULES FOR LAWN TRIMMER
AND EDGE TRIMMER
1. Keep guards in place and in working order.
2. Do not use this product without the guard
being fitted.
3. Keep hands and feet away from cutting
area.
4. Do not use heavier lines than
recommended in this manual.
14
5. Do not use line materials of other types –
for example, metal wire, rope, and the like.
12
SAVE THESE INSTRUCTIONS
12
APPLIANCE CORD
(A) tie cord as shown
(B) connect plug and
receptacle
9
EN
Publicité
