Worx WG119 Mode D'emploi page 11

TECHNICAL DATA
Rated voltage
Rated current
No load speed
Max.cutting diameter
Diameter of line
Line length
Weight
Protection class
ACCESSORIES
Flower guard
Auxiliary handle
Safety guard
Spool (WA0007)
We recommend that you purchase your
accessories from the same store that sold you
the tool. Use good quality accessories marked
with a well-known brand name. Choose the
type according to the work you intend to
undertake. Refer to the accessory packaging
for further details. Store personnel can assist
you and offer advice.
5.5A Electric Grass Trimmer/Edger
OPERATING INSTRUCTIONS
120V ~ 60Hz
5.5A
ASSEMBLY / ADJUSTMENT
7500/min
15˝
before use.
0.065˝ (1.65mm)
2x16' (2x5m)
1. INSTALLING THE SAFETY GUARD
6.0lbs (2.7kg)
(See Fig. A, B)
1) Disconnect the trimmer from the power
/II
from the power outlet BEFORE installing
parts or cleaning the trimmer or making
1
any adjustments.
1
2) Remove a screw from the guard; attach
1
1
when handling.
2. FITTING THE AUXILIARY HANDLE
(See Fig. C1)
NOTE: THE AUXILIARY HANDLE MUST
BE ATTACHED to the trimmer shaft
before use.
from the power outlet BEFORE installing
parts or cleaning the trimmer or making
any adjustments.
1) Disconnect the trimmer from the power
2) Unscrew the auxiliary handle's tightening
3) Position auxiliary handle onto handle
4) Position the knob and screw through the
NOTE: Before using the tool, read
the instruction book carefully.
NOTE: THE GUARD MUST BE
ATTACHED to the trimmer head
supply.
WARNING: To avoid injury, ALWAYS
turn off and disconnect the trimmer
the safety guard to the trimmer head.
Align the guard so it slides into the slots
located on the trimmer head. Turn the tool
over and secure the safety guard onto the
trimmer head with the screw provided.
CAUTION: Line cutter on edge of
safety guard is sharp. Use caution
WARNING: To avoid injury, ALWAYS
turn off and disconnect the trimmer
supply.
knob (counterclockwise) and remove from
handle.
bracket assembly located on trimmer's
top-shaft (See Fig. C1).
auxiliary handle and bracket, and tighten
knob (turn clockwise). (See Fig. C1) Do not
tighten completely until you have adjusted
11
EN