Publicité
Y
x 2
ZF
x 3
FIG. 8
8) Start two #8 x 1¼" Black Screws (Y) through the holes in the bottom of the Bottom Shelf (J).
Slide the Vertical Divider (M) over the 1/2" Cam Connectors (ZE) and insert 1/2" Cam Housings
(ZF) in the holes and tighten. The cam holes in the vertical divider must face toward Left Side
Assembly (G). Center the holes in the bottom edge of the Vertical Divider (M) over the screws and
finish tightening the screws. See FIGURE 8.
ZH
x 1
ZI
x 1
ZY
x 1
9) Attach a Front/Back Bottom Apron (H) to Left Side Assembly (G) in back with a 3" Barrel Bolt (ZH)
and Barrel Nut (ZI). Partially insert a Barrel Bolt in the hole in the side assembly. Put a Barrel Nut
(ZI) in the hole in the apron. Use a screwdriver to align the slot in the nut. Start the barrel bolt on
the nut and fasten securely, using the 4mm Allen Wrench (ZS).
Attach the apron (H) to the Back Vertical Support (L) with a #6 x 1" Oval Head Screw (ZY) through
the predrilled hole closest to the left side assembly (G). See FIGURE 9.
FIG. 9
140W — Page 9
Publicité
