Publicité
Z
x 12
ZA
x 6
ZE
x 10
ZK
x 7
FIG. 2
Read the instructions on how to operate CAM-LOCK SYSTEM at this time.
2) Glue 3/8" x 2" Wood Dowels (Z):
• Six in the Right Front Leg (A), five in the
narrow edge and one in the wide edge as
shown.
• Five in Right Back Leg (B)
• One in Left Side Assembly (G)
Glue 5mm x 25mm Wood Dowel (ZA):
• Three in holes along wide edge of Bottom
Right Apron (E)
• Three in the Left Side Assembly (G) near
the lower end
Page 6 — 140W
Insert 1/2" Cam Connectors (ZE):
• Three in holes near rear edge of Left Side
Assembly (G)
• Four in Top (W) as shown in FIGURE 2.
• Three in Back Vertical Support (L)
Insert 3/4" Cam Connectors (ZK):
• One in Back Vertical Support (L)
• One in wide side of Right Back Leg (B)
• Five in Top (W) as shown in FIGURE 2.
Publicité
