Publicité
FIG. 3
3) Lay out the parts as shown in FIGURE 3. Make sure the single 3/8" dowel (Z) in the Right Front
Leg (A), the 3/4" Cam Connector (ZK) in the Right Back Leg (B), the three 5mm dowels (ZA) in
Bottom Right Apron (E) and the three cam housing holes in the Top Right Apron (C) must all face
the same direction, i.e. towards the inside of the unit. Also, make sure that the three 5mm dowels
(ZA) in the Bottom Right Apron (E) are towards the top of the apron. Attach both Aprons to Right
Front Leg (A). Attach the Right Back Leg (B) to the other end of the aprons. See FIGURE 3.
The drawer slides will be stamped with an "L" for
ZB
x 6
left or an "R" for right in the center of the wheels.
Or they will be stamped on the body of the slide:
"CL" for cabinet left; "DL" for drawer left; "CR" for
cabinet right; "DR" for drawer right
FIG. 4
4) Install Drawer Slide (Cabinet Side Left) (ZC2) on the Left Side Assembly (G) using #6 x 1/2"
Undercut Screws (ZB) in the predrilled holes. The third hole in back end of the slide and the fifth
hole from the front will go over the predrilled holes. Insert a third screw in the elongated hole near
the front. Repeat with Drawer Slide (Cabinet Side Right) (ZC1) on the right side assembly.
Cam Housing Holes
ZK
C
B
.
Z
A
ZA ZA
ZA
E
140W — Page 7
Publicité
