Publicité
ZV
x 4
ZB
x 4
21) Insert the Shelf Brackets (ZV) in the holes at the locations where you want to place the Adjustable
Shelf (K). Make sure the wood trim on the edge of the shelf is facing out from the unit. The shelf
must be fastened in place with #6 x 1/2" undercut screws (ZB). See FIGURE 21.
Y
x 8
22) Attach two Drawer Sides (Q) to the Drawer False Front (P) with #8 x 1¼" Black Screws (Y)
through the predrilled holes in the sides. The grooves for the Drawer Bottom must line up. Slide
the Drawer Bottom (O) into the grooves. Attach the Drawer End (R) to the Sides in the same
manner. See FIGURE 22A.
Square the drawer by measuring from left front to right rear and from right front to left rear. The
measurements should be equal. If one is longer, hold the drawer by the corners on the longest
line and squeeze them together until square. See FIGURE 22B.
ZB
x 6
23) Attach Drawer Slides (Drawer Slide Left) (ZC4) and (Drawer Side Right) (ZC3) to the drawers.
The wheels should be to the rear and the front edge should be flush with the drawer side. Attach
the slides with three #6 x 1/2" Undercut Screws (ZB). See FIGURE 23.
ZV
FIG. 21
Y
Y
Y
Y
FIG. 22A
ZB
ZB
FIG. 23
ZB
FIG. 22B
ZC3
ZB
Y
Y
Y
Y
ZB
ZB
ZB
140W — Page 15
Publicité
