Publicité
ZQ
x 2
FIG. 24
24) Attach the Drawer Face (S) to the Drawer. Insert the #8 x 1¼" Machine Screws (ZQ) through
the center holes in the Drawer False Front and LOOSELY fasten the Drawer Pull (ZN) so that
it allows the adjustment of the Drawer Face but holds it in place once moved. See FIGURE 24.
DO NOT INSERT THE SCREWS (ZX) AT THIS TIME.
ZX
x 4
25) With the unit standing upright, insert the drawer. Adjust the Drawer Face (S) so that it is centered
between the legs and between the top and sleeper. Tighten the machine screws holding the
Drawer Pull to secure the drawer face in place. Insert the four LoProfile Screws (ZX) in the holes
in the False Front (P) and tighten securely. See FIGURE 25.
ZU
x 4
ZT
x 4
26) Tap a Metal Caster Insert (ZU) into the bottom of each leg. Tap all inserts in equally until the
little metal teeth are buried in the wood. Tap the Casters (ZT) into the inserts on each leg with a
padded hammer. See FIGURE 26.
Page 16 — 140W
FIG. 25
FIG. 23
ZQ
ZQ
ZX
ZX
ZN
Publicité
