Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Period
Service
Clean Battery
Check Fasteners
Every
100
Hours
Check Belts
Change Hydraulic Fluid
Every
and Filter
400
Hours
*Change hydraulic fluid and filter after the first 75 hours of operation and then
every 400 hours.
Ariens Dealers will provide any service which
may be required to keep your unit operating at
peak efficiency. Should engine service be
required, it can be obtained from a Ariens
Dealer or the engine manufacturer's
authorized service center.
WARNING: AVOID INJURY.
Read and understand entire
Safety section before proceeding.
CAUTION: HOT SURFACES
may result in injury. DO NOT
touch engine or drive parts which
are hot from operation. Allow
parts to cool before servicing.
SERVICE POSITION
1. Place unit on a flat level surface.
ALWAYS stop engine. Ensure unit is
secure and will not tip over. Strap and
clamp onto lift if used.
2. Place steering levers in neutral and
engage parking brake.
3. Remove wing knob.
4. Tip seat forward (Figure 6).
CAUTION: Be sure footing is
secure to accomodate weight
shift of seat when rotating it into
service position.
Task
Keep battery and its terminals clean. See Clean
Battery on page 22
Check mower blade mounting hardware and all
other fasteners. Replace missing or damaged
fasteners. Tighten all nuts and bolts to their correct
torque value.
Replace worn or deteriorated belts. See Replacing
Mower Belts on page 26 and Replacing the Hydro
Pump Belt on page 26.
Drain hydraulic fluid tank, replace hydraulic oil filter,
*
refill system. See Hydraulic Fluid on page 19.
SERVICE AND ADJUSTMENTS
.
5. When service is complete, lower seat
and secure with wing knob or hex nut.
2
OF4310
1. Service
Position
2. Steering
Levers
GB - 18
1
4
3. Parking Brake
4. Battery
Figure 6
2
3
Publicité
Chapitres
Table des Matières
