Ariens Max Zoom 2560 Mode D'emploi page 17

Period Service
Check Safety Interlock
Check Parking Brake
Interlock System
Check Hydraulic Fluid
Check Tires
Each
Use
Clean Unit
Follow Engine Manual
Maintenance Schedule
Check Mower Blades
Every
25
Hours
Check Air FIlter
Every
Lubricate Unit
50
Hours
Check Brake Gap
Task
WARNING: Safety interlock system
failure and improper operation of unit can
result in death or serious injury. Test this
system each time the unit is operated. If
this system does not function as
described, do not operate until repairs are
made. See Safety Interlock System on
page 12.
See Parking Brake Interlock System on page 12.
Check hydraulic oil level mark on cap/dipstick. Add
20W50 engine oil as needed. Do not overfill. See
Check Hydraulic Fluid Level on page 19.
See Specifications on page 31for correct tire
pressure.
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is possible
when they are serviced incorrectly:
• Do not attempt to mount a tire without the
proper equipment and experience to
perform the job.
• Do not inflate the tires above the
recommended pressure.
• Do not weld or heat a wheel and tire
assembly. Heat can cause an increase in air
pressure resulting in an explosion. Welding
can structurally weaken or deform the
wheel.
• Do not stand in front or over the tire
assembly when inflating. Use a clip-on
chuck and extension hose long enough to
allow you to stand to one side.
Clean engine, battery, seat, mower deck, etc. of dirt
and debris. Do not use solvents, hard cleaners, or
abrasives.
Do not spray the unit with water, especially when
the unit is warm from operation. Water can seep
into bearings and damage them.
NOTE: Protect painted surfaces with automotive
type wax.
Perform scheduled engine maintenance. Refer to
engine manual for detailed instructions.
Check mower blades for wear. Sharpen or replace
as needed. See Mower Blades on page 20.
Check air filter for dirt. Clean as required. Follow
Engine Manual for maintenance schedule.
Oil all pivot points and pin connections. Grease
lube fittings. See Lubricate Unit on page 23.
Adjust gap if necessary. See Adjusting the Parking
Brake on page 25.
GB - 17