Service And Adjustments; Service Position; Handlebar Height - Ariens 911173-LMP Manuel Du Propriétaire/Utilisateur

All manuals and user guides at all-guides.com

SERVICE AND ADJUSTMENTS

CAUTION: AVOID INJURY. Read
and understand the entire
section before proceeding.

SERVICE POSITION

Put unit into service position for easy access
to bottom of deck.
CAUTION: Avoid fuel spills. Follow
steps below to help prevent fuel
spills. If fuel leaks into air cleaner,
replace air cleaner. ALWAYS
clean up any spilled fuel.
1. Place unit on a flat, level surface.
2. Disconnect spark plug wire.
3. Remove fuel cap.
4. Place a piece of plastic bag over the
opening and tighten cap securely.
5. Remove discharge chute if installed.
6. Tip unit onto right side.
Make sure unit is secure and will not tip
over.
IMPORTANT: Remove plastic from fuel cap
after unit is upright and service is complete.

HANDLEBAR HEIGHT

(911173)
To adjust (Figure 13):
1. Remove hardware from lower handlebar
mounting hole.
2. Rotate the handlebar to the desired
position and align the mounting holes
with the holes in the handlebar upright.
3. Secure handlebar with hardware
removed in step 1.
NOTICE: To fold handlebar flat for storage,
remove the hardware from the lower
handlebar mounting holes, rotate the
handlebar forward, and then tighten the
hardware in the holes on the handlebar.
Safety
1. Handlebar
2. Mounting Hardware
HANDLEBAR HEIGHT
(911175, 179)
To adjust (Figure 14):
1. Push the engine/blade control forward
slightly and rotate handlebar to the
desired position.
NOTICE: To fold handlebar flat for storage,
push the engine/blade control forward slightly
and rotate handlebar forward and down
toward mower frame.
1. Engine/Blade Control
EN - 20
2
1
Figure 13
1
Figure 14