Handlebar; Operation; Cutting Height Adjustment - Ariens 911173-LMP Manuel Du Propriétaire/Utilisateur

All manuals and user guides at all-guides.com
CONTROLS AND FEATURES
See Figure 6 for locations.
WARNING: Improper operation
can lead to injury. Learn what the
controls do and how they work.
Thoroughly read and understand
entire Operator Manual.
CAUTION: AVOID INJURY. Read
and understand the entire
section before proceeding.
Engine/Blade Control
CAUTION: Check function of
Engine/Blade Control regularly.
Improper function of control could
cause injury.
The engine/blade control must be held
against the handlebar to start the engine and
blade.
Engine/blade control feature stops engine
and blade within 3 seconds of operator
releasing handlebar. Check this feature
frequently. If feature fails to operate,
disconnect spark plug wire and adjust or have
it repaired before using unit.
STOP START and RUN

Handlebar

Adjust handlebar to a safe and comfortable
height. See HANDLEBAR HEIGHT on
page 20.
Recoil Starter Handle
When pulled, handle will turn engine over.

OPERATION

CUTTING HEIGHT ADJUSTMENT

DANGER: Avoid injury from
rotating blade.
ALWAYS shut off engine before
adjusting cutting height.
Cutting Height Settings Chart
Notch
Safety
To change cutting height, move cutting height
levers one notch at a time to set desired
height (Figure 7).
1
1. Cutting Height Lever
2. Lowest Position
3. Highest Position
EN - 13
Cut grass length
1" (25 mm)
1
2 1-1/2" (38 mm)
3 2" (51 mm)
4 2-1/2" (64 mm)
5 3" (76 mm)
3-1/2" (89 mm)
6
4" (102 mm)
7
3
2
Figure 7