Camp Safety 0284 Mode D'emploi page 6

INSTALLING THE REF.0284-028401 ON THE TRIPOD EVO REF.1883
1. Open the grip
Locking hole
Locking pin
4. Close the grip. Lock the grip
using the lever.
6. Anchor the pulley to the 6. Anchor the pulley to the
central anchor eye bolt of central anchor eye bolt of
the tripod. Both walls of the tripod. Both walls of
the pulley should be the pulley should be
linked together using the linked together using the
connector supplied with connector supplied with
the pulley. Ensure the the pulley. Ensure the
connector is closed and connector is closed and
locked. locked.
8. Attach the energy absorber
to the cable using the
connector suppllied with the
absorber.
2. Put the 0284-028401 on
the triopd's leg. The
grip of the 0284-
028401 must be
fastened on the locking
hole situated on the
bottom wall of the leg's
profile.
9. Connect absorber's
3. Fit the locking pin into the
hole in the tripod's leg.
5. Guide the rope behind 2 bolts
located above the reel.
7. Put the rope on the
pulley. Ensure that the
cable is correctly placed
on the roller of the pulley.
connector to the
attachment element
of a harness. Use
"A" frontal or dorsal
attachment point in
full body harness
(EN 361) or rescue
arttachment point in
rescue harness (EN
1497) or rescue
loops (EN 1498).
rope
bolts
EN 2/4