Camp Safety 0284 Mode D'emploi page 5

Instruction Manual
Read carefully
the manual
before use
the equipment
The rescue lifting device ref.0284-028401 is a component of rescue system. Using ref.0284-028401 the rescuer can lift the other person from a lower to a higher place
or lower him over a distance limited to 2 m. The ref.0284-028401 is designed to use with the TRIPOD EVO ref.1883.
The rescue lifting device ref.0284-028401 complies with EN1496:2017 Class B.
TECHNICAL DATA
! max. working load: 140 kg
! hand force required: 22 kG
automatic brake which intervenes to avoid self-
!
contained descent of the worker;
integrated rope diameter: ø 6,3 mm
!
Length of the cable: 20m (ref.284), 25 m (ref.028401)
!
! Max. lifting distance: 25 m
hand operation
!
CAUTION!
! It is forbidden to use the rescue lifting device 0284-028401 as the protection against falls from a height. When there is a danger of falling from a height additional
secondary fall arrest system conforming EN 363 must be used.
! The lifting / lowering function is for rescue purposes only and not for lifting / lowering loads.
! Always operate the device 0284-028401 with hand power and with crank included in the equipment only.
! Never allow to full extention of the working rope from the reel. Keep at least three rope fakes on the reel
- it is marked by a special safety sign which is situated on the rope. Stop extend the rope from the reel
when the red safety sign appears! Obligatory check a condition of the safety sign. See picture A.
! before each use, a close visual examination of the device cover, reel, snap hook, crank, holder and
working cable must be carried out in respect of mechanical, chemical and thermal defects. The user
has to check the reel and brake functioning. The examination must be carried out by a person who is
going to use the device. Check also the stability of fastening the winch to a tripod. In the case of any
defect or doubt of correct condition of the device, do not use the device.
! There should be direct or indirect visual contact or some other means of communication with the
rescuee at all times during the rescue process.
! using the device 0284-028401, in connection with fall arrest system, must be compatible with manual
instructions of the fall arrest systems and obligatory standards:
- EN 361, EN 341, EN 1497, EN 1498 - for body holding devices;
- EN362 - for the connectors;
- EN795 - for anchor devices;
- EN353-1, EN353-2, EN354, EN 355, EN360- for fall arrest systems.
RESCUE
LIFTING DEVICE
Ref. 0284 (20 m) - 028401 (25 m)
EN 1496:2017
pulley
cable
cable
connector
identity label
absorber's
connector
CLASS B
pulley's connector
crank
one
piece
reel
Pict. A
STOP EXTENDING THE WIRE
WHEN THE RED SAFETY
TP TC
019/2011
automatic
locking
brake
lever
inside
the cover
grip
FROM THE REEL
SIGN APPEARS
EN 1/4