V2 FORTECO Serie Mode D'emploi page 53

DISPLAY DATA DESCRIPTION
AUS Auxiliary channel
tiM - Time working
biSt - Bistable working
Mon - Monostable working
LP.PA no/Si Flashlight in pause
St.rt Operation modes
StAn - Start inputs from terminal board are disabled
no - Standard operation
AP.CH - Separated opening and closing commands
PrES - Manned operation
oroL - Timer operation
StoP STOP input
no - STOP input not available
invE - STOP command stops the gate: START command starts moving in the opposite direction
ProS - STOP command stops the gate: pressing the START command gate continues the motion
Fot 1 PHOTO 1 input
APCh - Input is available for the connection of the photocell
no - Not available
Fot 2 PHOTO 2 input
CFCh - Photocell is active in closing and also when the gate is still
no - Not available
Ch - Photocell is active during the closing
Ft.tE no/Si Test of operating of the photocells:
CoS1 Input safety edge 1 (fix edge)
no - Non-active input
AP - Input active only in opening
APCH - Input active both in opening and closure
CoS2 Input safety edge 2 (mobile edge)
no - Non-active input
CH - Input active only in closure
APCH - Input active both in opening and closure
Co.tE Test of operating of the safety edges:
no - Test disabled
Foto - Test enabled for optical type safety edges
rESi - Test enabled for resistive rubber safety edges
W.L. - Test enabled for wireless edge system
FC.En no/Si End of stroke inputs
EnCo no/Si Encoder Input
S.EnC 0 ÷ 7 Encoder sensitivity
ASM 0.5" ÷ 1.0' Anti-skid function
no - Function disabled
FinE End of programming
no - It does not exit from the program menu
Si - It exits from the program menu by storing the setup parameters
PD18 FUNCTION TABLE
51
MEMO
DEFAULT
DATA
1'00
no
StAn
no
no
CFCh
no
no
no
no
Si
no
0
1.0"
no