Pd18 Function Table - V2 FORTECO Serie Mode D'emploi

DISPLAY DATA DESCRIPTION
t.AP 0.0" ÷ 5.0' Gate opening time
t.APP 0.0" ÷ t.AP Opening time of pedestrian gate
t.Ch 0.0" ÷ 5.0' Gate closing time
t.ChP 0.0" ÷ t.Ch Closing time of pedestrian gate
t.PrE 0.5" ÷ 1.0' Pre-flashing time
no - Pre-flashing disabled (it corresponds to 0)
dir Gate direction (the direction you see from the inside)
dx - The gate opens rightwards
Sx - The gate opens leftwards
Pot 35 ÷ 100% Motor power
SPUn Si/no Start off
rAM 0 ÷ 6 Starting ramp
FrEn 0 ÷ 10 Brake function
SEnS 0.0A ÷ 9.9A Obstacle sensor
t.raL 0.5" ÷ 1.0' Slow down time
no - Slow down disabled
St.AP Start in opening
no - Start command is not available
ChiU - Command close gate
PAUS - Stop the gate and goes in pause
St.Ch Start in closing
Stop - Start command stop the gate
APEr - Start command open the gate
St.PA Start in pause
no - Start command is not available
ChiU - Start command closes the gate
PAUS - The pause time is reloaded (Ch.AU)
SPAP Pedestrian in opening
no - Pedestrian start command is not available
ChiU - Pedestrian start command closes the gate
PAUS - Gate goes in pause
Ch.AU Automatic closing
no - The gate closes after the setup time)
0.5"÷ 20.0' - The automatic closing is not active (it corresponds to 0)
Ch.tr Closing after passage
no - Closing after passage disabled
0.5"÷ 20.0' - Gate stop for a time to be set between 0.5" to 20'
PA.tr no/Si Pause after transit
LUCi Courtesy lights
t.LUC - Time working (from 0 to 20')
no - Function disabled
CiCL - On all the cycle long

PD18 FUNCTION TABLE

50
MEMO
DEFAULT
DATA
22.5"
6.0"
23.5"
7.0"
1.0"
dx
80
Si
4
0
0.0A
6.0"
PAUS
StoP
ChiU
PAUS
no
no
no
1'00