Description Of The Control Unit; Installation; Power Supply; Blinker - V2 FORTECO Serie Mode D'emploi

DESCRIPTION OF THE CONTROL
UNIT
The digital control unit PD18 is an innovative V2 S.p.A. product
that guarantees a safe and reliable automation of sliding gates.
The PD18 has been designed to realize a product that meets all
kind of requirements, with a highly versatile control unit that
satisfies all the necessary requirements for a functional and
efficient installation.
PD18 is provided with a display that, not only makes
programming simple, but also allows a continuous monitoring of
the input statuses; in addition, thanks to a menu structure, the
working schedule and the operation logic can be set easily.
In compliance with the European standards concerning
electrical safety and electromagnetic compatibility
(EN 60335-1, EN 50081-1 and EN 50082-1) it has been
equipped with the low voltage circuit total electric insulation
(motors included) from the network voltage.
Other characteristics:
• Automatic control for the null current relay switch.
• Power adjustment with wave shutting.
• Obstacle detection through monitoring of the current on the
motor (amperometric)
• Automatic learning of the operation time.
• Tests for safety devices (photocells, safety ribbons and triacs)
before each opening.
• Deactivation of safety inputs through the configuration
menu: no jumper is required for terminals concerning safety
devices that have not been installed, yet. You will only need
to disable this function from its relevant menu.

INSTALLATION

Installation of control unit and safety devices must be carried out
with power disconnected.

POWER SUPPLY

The control unit must be fed by a 230V - 50Hz (120V - 50/60Hz
for the model PD18-120V) electric line, protected by a differential
magnetothermal switch complying with the law provisions in force.
Connect power supply cables to terminals L and N of PD18
control unit.
Connect the motor to ground through the clamp marked by the
symbol
Use the eyelet provided.

BLINKER

PD18 control unit provides for a 230V 40W (120V - 40W for
model PD18-120V) blinker equipped with intermittence inside.
Connect blinker cables to terminals B3 and B4 of the control
unit.
COURTESY LIGHTS
Thanks to the output COURTESY LIGHT the control unit
allows the connection of an electric appliance (e.g. courtesy
light or garden lights), controlled automatically or by means of
the special transmitter key.
The output COURTESY LIGHT is a simple N.O. contact with no
power supply.
Connect the cables to terminals B1 and B2.
33