Capture Using Multi-Mode; Review Images - Nikon OPTOS Monaco P200TE Manuel D'utilisation

Patient Session Summary
The Patient Session Summary is displayed when you select
confirm the image and laterality counts are as expected. If the session in incomplete or incorrect select outside
the summary to continue the session.

3.2.9 Capture using Multi-mode

Multi-mode
provides a workflow assistance mode. It allows the operator to perform a defined sequence of SLO
and OCT captures, by stepping through the desired mode settings.
The following image modalities are captured in the sequence shown:
Multi-mode Red/Green
image 1 -
Multi-mode image 2 - opto map
Multi-mode image 3 - Optos OCT
1. Select
Multi-mode
2. Position the patient, see How to prepare for image capture on page 36 .
3. Capture the
Red/Green
4. Check the quality of the captured image and discard and recapture if required. The device will then
select opto map af
5. Capture the opto map
6. Check the quality of the captured image and discard and recapture if required. The device will then
select Optos OCT
7. Capture the Optos OCT
8. Check the quality of the captured image and discard and recapture if required.
9. Select Finished multi-mode

3.3 Review images

To record characteristics and observations of a patient's eye,
these observations in the patient's electronic medical record.
You can get help reviewing images in the software help files.
Part Number: G108707/8GWE
Copyright 2018, Optos plc. All rights reserved.
af
raster scan
and the required laterality.
image, see How to capture SLO images on page 39 .
as the next image to be captured.
af image.
raster scan as the next image to be captured.
raster scan, see How to capture OCT images on page 48 .
.
Finished Patient . You should check the summary to
OptosAdvance has a range of tools for noting
Chapter 3 - How to...
Page 51 of 76
English