Nikon OPTOS Monaco P200TE Manuel D'utilisation page 17

Cleaning the main mirror
The mirror can be damaged during cleaning. Preventing mirror contamination reduces the
risk of damaging the mirror. It is
Only clean the mirror if dust particles, smudges or spots have accumulated on its surface.
When cleaning the main mirror, do
Do touch the edges of the main mirror. The edges of the main mirror are sharp.
NOT
Only clean visible areas of the main mirror. Do
CAUTION
into parts of the device you cannot see.
Do polish the mirror surfaces; clean only dust particles, smudges or spots.
NOT
Do wear jewelry (for example rings, watches or bracelets) while cleaning the mirror
NOT
surface as this may damage the mirror.
Dispose of the dirty cloth after each wipe to avoid transferring the dust back on to the
mirror. You will have to use several wipes to clean the mirror.
Cleaning materials
Wear powder-free gloves at all times when cleaning the device including the scan head
and main mirror. If the gloves become contaminated they must be replaced immediately.
Do use lint cloths, tissues, or other materials that may create dust, on or near the
NOT
scan head. Always allow cleaned areas to air-dry.
Improper cleaning methods or use of inappropriate cleaning and disinfecting agents can
result in the following:
l
l
l
Always follow the cleaning and disinfecting agents' manufacturer's instructions and
precautions; for storage, method of application, protective gloves, shelf life and disposal
to help assure effective and safe use of the product.
CAUTION
Be careful
Do use harsh detergent, abrasive cleaners or solvents that are
NOT
the manufacturer.
Do expose equipment parts to steam or sterilizers as this will damage the device.
NOT
Do allow liquids to get into the equipment.
NOT
If you believe cleaning sprays or liquids have got into the equipment, disconnect the
power supply and have the equipment checked by Optos qualified service personnel.
Do let the cleaning wipes come into contact with the inside of the instrument.
NOT
Do use the equipment until you have confirmed it is safe to use.
NOT
Part Number: G108707/8GWE
Copyright 2018, Optos plc. All rights reserved.
NOT
NOT
Damaged equipment
Poor imaging performance
Increased risk of electric shock
to damage the scan head covers when cleaning.
NOT
recommended to routinely clean the main mirror.
rub the spots too hard, as this may cause damage.
put your hand or any cleaning material
NOT
Chapter 1 - Warnings and cautions
recommended by
NOT
Page 17 of 76
English