Breville the Oracle Manuel D'instructions page 20

AUTO START
Auto Start is optional. It allows you to
program the specific time when the machine
will automatically turn on. By programming
your machine, you will not have to wait for it
to pre-heat. We recommend programming
the machine to start 30 minutes before you
plan to use it.
NOTE
The clock must be set before the Auto Start
time can be programmed. If you try to turn
Auto Start on without first setting the clock, the
machine will beep 3 times.
While 'AUTO START' is displayed on the LCD,
press the SELECT dial. Turn the SELECT dial
to on (On) or off (oFF).
Press SELECT dial to set.
SELECT SELECT SELECT
TEMP TEXTURE TEMP TEXTURE TEMP TEXTURE
20
Turn the SELECT dial to the left or right to
select the desired Auto Start time. Turning
the SELECT dial faster or slower will change
the rate of adjustment. When required time
has been reached, press the SELECT dial to
set. A small clock icon will be displayed on
the LCD when the Auto Start function has
been programmed.
AUTO OFF
This function sets how long the machine will
stay turned on before it automatically turns
off. It can be set for 10mins, 30mins, 1hr, 2hrs,
3hrs, 4hrs, 5hrs, 6hrs, 7hrs or 8hrs until Auto
Off activates.
While 'AUTO OFF' is displayed on the LCD,
press the SELECT dial. Turn the SELECT dial
to the desired time then
press SELECT dial to set. Machine will beep
once to confirm selection.
SELECT SELECT SELECT
TEMP TEXTURE TEMP TEXTURE TEMP TEXTURE
SELECT SELECT SELECT
TEMP TEXTURE TEMP TEXTURE TEMP TEXTURE
SELECT SELECT SELECT
TEMP TEXTURE TEMP TEXTURE TEMP TEXTURE