Attaching The Auxiliary Handle; Attaching And Replacing Roughing / Grinding / Cutting Discs - Parkside PWS 230 A1 Instructions D'utilisation Et Consignes De Sécurité

socket before you carry out any task
on the device.
DANGER OF INJURy! Always use the
angle grinder with the disc guard
cover in place. The disc guard cover must
be securely attached to the angle grinder. To
ensure the highest level of safety while using
the device, ensure that the smallest possible
area of the grinding or cutting tool is exposed
to the operator at all times. The disc guard cov-
er is there to protect the operator from pieces
breaking off and accidental contact with the
grinding or cutting tool.
DANGER OF INJURy! Ensure that the
guard is attached so that its edge
7
is beyond the angle of the auxiliary
handle (see Fig. B). Otherwise you
6
could injure yourself against the grinding or
cutting disc.
Open the clamping lever
Insert the disc cover guide
projection in the coded groove
9
Turn the disc guard cover
position (working position). The closed side of
the disc guard cover
the operator.
Close the clamping lever
the disc guard cover
If necessary the clamping force of the connection
can be adjusted by tightening or loosening the
adjuster screw .
10
Ensure that the disc guard cover
on the spindle collar.

Attaching the auxiliary handle

Q
CAUTION! For safety reasons this
device must always be used with the
auxiliary handle
you could become injured.
Pull the mains plug out of the mains
socket before you carry out any task
on the device.
Screw the auxiliary handle
or on the top of the head of the device.
.
8
with the coded
7
.
16
into the desired
7
must always be facing
7
to firmly clamp
8
in place.
7
sits firmly
7
in place. Otherwise
6
DANGER OF INJURy!
on the left, right
6
Attaching and replacing
Q
roughing / grinding / cutting discs
Take note of the dimensions of the roughing /
grinding or cutting discs. The circular hole must fit
on to the mounting flange without play. Do not use
a reducer piece or adapter.
Pull the mains plug out of the mains
socket before you carry out any task
on the device.
Check the condition of the roughing /
grinding or cutting discs. They must be
free of damage, moisture or cracks.
Otherwise they could break up during use and
cause injury.
DANGER OF BURNS! Always wear
protective gloves when changing a
roughing / grinding or cutting disc.
Roughing / grinding and cutting discs become
hot during use. Do not touch them until after
they have cooled down.
NOTE: Always ensure the discs are free of dirt
before use.
Use only abrasive consumables or tools with
an allowable speed at least as high as the
no-load speed of the device.
DANGER OF INJURy! Press the spindle lock
button only after the mounting spindle
11
has reached a standstill.
Press the spindle lock button
Release the clamping nut
(see Fig. C).
17
Place the roughing / grinding or cutting disc on
to the mounting flange
facing towards the device.
Then replace the clamping nut
raised side facing upwards, on to the mounting
spindle .
14
Press the spindle lock button
Tighten the clamping nut
spanner .
17
NOTE: Replace a new disc immediately if it
runs unevenly or vibrates after being exchanged.
After replacing a disc let the device run under
no-load conditions for 30 seconds as a safety
check. Look out for unusual noises or generation
Preparing for use
DANGER OF INJURy!
14
to block the drive.
11
using the spanner
13
with its labelled side
15
, with its
13
to block the drive.
11
again with the
13
GB 43