Look 796 MONOBLADE RS Notice D'instructions page 65

3- Feed both Di2 wires coming from the right hand side of the bar into the right side of the cap,
and the two from the left to the left. (fig. 9.1)
4- Connect the wires from the left to the ports on the left and the wires from the right to the
ports on the right. Connect the wire from the frame to the box's central port.
5- Retighten the screw in the cap
6- Position the box on the sheet, forming the wires into a loop. (fig 9.2)
7- Pass a plastic tie collar
take the wire that goes into the frame (fig 9.3)
Fig. 9.1
Volume (mm3)
23008.52
Dessiné par
P.BIGARD
Vérifié par
Note : le 796 is not compatible with the Shimano SM-EW90-A box (3 ports).
All information contained on this drawing is property of LOOK CYCLE INTERNATIONAL. Its reproduction for any use in any way or for commercial
purpose is forbidden. All rights on this material are reserved.
Nature de la modification
ECHELLE 1:1
Masse (g)
37.77 FORMAT A4
Dessiné par Date
P.BIGARD
1
2
② around the 4 wires under the box to hold them together. Do not
1 1
Fig. 9.3
Nature de la modification
Volume (mm3)
23008.52
ECHELLE 1:1
Masse (g)
37.77 FORMAT A4
Date
All information contained on this drawing is property of LOOK CYCLE INTERNATIONAL. Its reproduction for any use in any way or for commercial
Date purpose is forbidden. All rights on this material are reserved.
Assemblage_capot_boitier
Resp
Matière
ENSEMBLE
CD-CLM22
DESIGNATION
②.
1 1
Fig. 9.2
Nature de la modification
Resp
Matière
ECHELLE 1:1
Masse (g)
37.77 FORMAT A4
Dessiné par Date
ENSEMBLE REFERENCE PROTO.
2
P.BIGARD
CD-CLM22
Vérifié par Date
DESIGNATION
Date Ind.
Traitement
REFERENCE PROTO.
REFERENCE
1 1
2
Matière
Date Ind.
Traitement
ENSEMBLE
CD-CLM22
DESIGNATION
Assemblage_capot_boitier
REFERENCE
EN
2
Resp Date Ind.
Traitement
REFERENCE PROTO.
REFERENCE
16