LAS 11807 Instructions De Montage page 9

Belt guides Wheel rail end caps Basic frame
Start with the preparation of the wheel rails. Shove 2 slot nut screws M6 x 50 each into the link
under the wheel rail. At 2 rails insert 1 belt guide and at the both other rails 2 belt guides also in
the link.
Put the wheel rail end caps on both ends of the wheel rails. Now position the wheel rails on the
basic frame and slide the thread of the slot nut screws into the provided boreholes of the basic
frame and secure them with the 6 mm washers and the plastic toggle nuts. Please consider,
that 1 wheel rail each with one, respectively with 2 belt guides make one wheel unit. (2 belts for
the front wheel and one for the rear wheel) The belt guides point to the outsides. The wheel rails
can be adjusted easily after loosening the toggle nuts.
Picture 2
Required parts
U – bolt U – bolt fastenings
Boreholes
9