LAS 11807 Instructions De Montage page 12

In case of cross winds lower your speed. Take care that no attachment parts on the bicycle can
get lost (bicycle tyre inflator, baskets, bicycle bell etc.). Avoid jerky braking, acceleration and
steering movements. Only use original parts for exchange.
For correct and secure mounting follow the assembly instructions exactly. In case of doubt of
these instructions contact the dealer or the manufacturer directly for further information.
For your own safety you should check the carrier and the corresponding load at regular inter-
vals, as you are obliged to do so according to § 23 of the Road Traffic Regulations and in case
of any damage you can be hold liable.
The manufacturer and the dealer absolve themselves of responsibility for any damages
to property or persons based on incorrect mounting or improper use
The product was checked also tested under extreme conditions, whereas good results were
achieved in regard to safety and stability. When installed correctly we can exclude any malfunc-
tion.
Dear customer, thank you for buying this product.
This drawbar carrier was checked for completeness. The aluminium drawbar carrier has a dead
weight of approx. 4 kg without fastening parts and approx. 6 kg with fastening parts. The fasten-
ing parts are made of stainless steel and plastics !
Exploded view
Pipe clamp
Plastic bloc
Attachment clamp
Drawbar area
12