Countertop Requirements; Ventilation Requirements - Bosch NGMP0777UC Manuel D'installation

Hook Up
Plan the installation of the unit so that the power cord,
gas shut-off valve and gas pressure regulator are
accessible from the front of the cabinet.
The supply line must not interfere with the back of the
unit.
Make sure the gas supply is turned off at the manual
shut-off valve before connecting to the appliance.

Countertop Requirements

WARNING
To reduce the risk of ignition of surrounding
combustible materials, install at least 12¾"
(325 mm) from both sidewalls and at least 2¼"
(58 mm) from the rear wall.
The countertop must be level and horizontal. The stability
of the countertop must be maintained after the cut-out
has been made.
Note: All measurements given must be precisely
followed. If nonstandard cabinets are used, make sure
they are installed with minimum dimensions shown in the
following image.
* for installation in a kitchen island
For flush installation:
All cut-out work in the countertop surface should be
performed by a qualified craftsman.
The cut-outs should be clean and precise, as the cut
edge will be visible after installation. The stability of the
countertop must be ensured after cutting work.
Use only specially designed work surfaces, resistant to
high temperature and water (e.g. natural stone or tile).
Surrounding cabinetry must be resistant to
temperatures of up to 195° F (90°C).
* for installation in a kitchen island

Ventilation Requirements

We strongly recommend the installation of ventilation with
the appliance. The appliance must be installed according
to the ventilation instructions.
CAUTION
The appliance should not be installed with a
ventilation system that blows air downward toward
the burners. This type of ventilation system may
cause ignition and combustion problems with the
gas cooking appliance resulting in personal injury or
unintended operation.
* When installed in combination with a hood, refer to
hood manufacturer’s requirements for installation.
7