Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Conversion to LP Gas
The components required for this are contained in the
conversion kit included with this appliance, or are
available from Customer Service.
Important: After finishing, attach the sticker indicating
the new gas type close to the rating label if you change
to LP Gas, or remove the sticker if you are changing
back to Natural Gas.
Converting the Pressure Regulator
Locate the pressure regulator on the bottom right end of
the cooktop.
Note: The arrow on the back of the regulator must point
in the direction of the gas flow to the cooktop.
1. Remove the hexagon shaped cap from the regulator
making sure not to dislodge the gasket on the cap or
the spring inside the regulator.
2. Grasp the plastic button stem firmly and pull it
forcefully from the metal cap. The stem snaps snugly
into an indent in the cap and may require a strong pull
to remove. (Hint: it may be helpful to gently “rock” the
plastic stem while pulling it from the metal cap.)
A
Spring
B
Plastic button stem
C
Gasket
12
3. After removing the stem from the cap, rotate the stem
180° so the button end of the stem is away from the
cap and the letters “LP” on the stem are upside down
when the cap is set flat on its head. Snap the stem
back in place in this position inserting it into the indent
in the metal cap.The stem should snap into place.
4. Important: Attach the metallic sticker (included with
this conversion kit) to the bottom of the appliance as
shown, placing it near the appliance rating label
(shows model number and information about the
appliance). This sticker provides notice that the
appliance has been converted for use with LP gas.
Replacing the Nozzles
Replacing the nozzles
1. Remove all burner grates, burner caps and burner
bases.
2. To replace the nozzles, use a 7 mm socket wrench.
See table. It is important to make sure that the nozzles
do not become detached during removal or fastening.
They must be properly tightened to ensure that there
are no leaks.
With these burners, there is no need to adjust the
primary air.
Publicité
Chapitres
Table des Matières
