Prepare Installation Space
Create the cut-out in the countertop according to the
installation diagram. The angle of the cut surface to the
countertop must be 90°.
The lateral cut-out edges must be flat in order to ensure
that the retaining springs are positioned properly on the
appliance. With multi-layered countertops, secure strips
laterally in the cut-out if necessary.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat- and water-resistant manner.
Observe minimum distance between device underside
and cabinet surfaces of
Installation Procedure
CAUTION
9
Sharp edges. Use protective gloves when installing
the cooktop.
Secure cooktop to countertop
The cooktop should be secured to the countertop using
the clamps provided.
/
" (10 mm).
3
8
I n s t a l l a t i o n P r o c e d u r e
P r e p a r e I n s t a l l a t i o n S p a c e
Cutout dimensions
Prior to inserting cooktop into cutout, attach clamps to
1.
the corresponding slots.
5