Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Prepare Installation Space
Create the cut-out in the countertop according to the
installation diagram. The angle of the cut surface to the
countertop must be 90°.
The lateral cut-out edges must be flat in order to ensure
that the retaining springs are well-positioned on the
appliance. With multi-layered countertops, secure strips
laterally in the cut-out if necessary.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat- and water-resistant manner.
Observe minimum distance between device underside
and furniture parts of
/
3
8
Installation Procedure
CAUTION
9
Sharp edges. Use protective gloves when installing
the cooktop.
Install appliance
Evenly insert the unit in the cut-out. Press the unit firmly
into the cut-out from above.
Note: The unit must sit firmly in the cut-out and must not
move (e.g. during cleaning).
" (10 mm).
Cutout dimensions
5
Publicité
Chapitres
Table des Matières
