Filling The Water Tank - Klarstein Iceberg Pure Mode D'emploi

EN
28
• When the humidification function is activated and the water level switch is closed,
the pump starts working.
• When the appliance starts and the humidification mode is off, the pump runs in the
following cycle: runs 3 s > stops 3 s > runs 3 s > stops 3s > continues to run.
• If the appliance is running in humidification mode or the humidification function
is activated and the water level in the water tank is low, an alarm signal (3 long
tones) sounds and the display flashes at 1 Hz until the humidification function is
deactivated or the appliance is switched off.
• Fill water into the water tank. The alarm stops as soon as the water level in the water
tank has been refilled. However, the air humidification function must be switched on
again manually.
• The air humidification function is saved during a lack of water.

FILLING THE WATER TANK

• Rotate the water tank switch to the horizontal position and then remove the water
tank. After removing the water tank, fill it with water, ice packs or ice.
• Only fill the water tank with water or ice up to the maximum water level mark.
• After filling, push the water tank back into the original position and turn the water
tank switch to the vertical position to lock the water tank.
• If you use the ice packs, please put them in the fridge to freeze them. Using frozen
ice packs has a certain cooling effect and cools down the blown out fan air.
WARNING
Risk of injury! The liquid in the ice packs can be harmful to health! If the
liquid has been swallowed, consult a doctor immediately. If the liquid
has come into contact with your eyes, rinse them out with water and
consult an eye doctor immediately.