Publicité
Les langues disponibles
Les langues disponibles
No MASTER
This fault is displayed if there is not a chain counter with MASTER priority in
the CAN network (see chapter MULTIPLE CHAIN COUNTERS).
See if the MASTER chain counter is on and the data line connections.
The window shown below appears when this problem is present:
CAN BUS communication error
This fault is displayed if there are errors that cannot be recovered during
CAN network communication.
Make sure the data cables are properly connected.
The window shown below appears when this problem is present:
PROBLEMS WITH AUTOMATIC RESET AND KEYS LOCKED
These faults are automatically reset as soon as the cause that had generated the problem disappears.
Some keys are disabled when these faults are present.
Opposed commands
This fault is displayed if keys UP or DOWN are pressed at the same time as
the respective external control DOWN or UP key (other chain counters or
other remot switch).
If the fault is present, keys
The window shown below appears when this problem is present:
Inside Fuse open
This fault is displayed if the inside the chain counter has blown (open) due
to an overload or output short circuit.
The fuse can be replaced only at an authorized service center.
If the fault is present, keys,
The window shown below appears when this problem is present:
Remote programming active
This fault is displayed if a chain counter has entered the SETTINGS menu in
the CAN network (see chapter MULTIPLE CHAIN COUNTERS). Wait until the
chain counter has exit the menu.
If the fault is present, key
The window shown below appears when this problem is present:
,
(UP, DOWN) are disabled.
,
(UP, DOWN) are disabled.
(SELECT) is disabled.
SYSTEM FAULTS
NO MASTER
SPEED
CAN ERROR
SPEED
OPPOSED
SPEED
FUSE OPEN
SPEED
REMOTE PROG
SPEED
GB
0 M / M
0 M / M
0 M / M
0 M / M
0 M / M
29
Publicité
