Vermeiren Eagle 620 Manuel D'utilisation page 19

4.2.3 Dismantling
WARNING: Risk of clamping - Take care that no body parts and wires get trapped,
L
crushed or cut during dismantling.
WARNING: Risk of injury - Check the emergency stop (red pushbutton on the control
L
box) is activated, to avoid unintentional adjustment movements.
4. Undo the transport strap (Velcro) of the spreader bar. This
can now be moved freely to the end of the pole.
1. Secure the two casters at the back of the chassis by pressing
the caster brake plates down gently to their end stops with
the tip of your foot. To release the brake, push the brake plate
gently back up again with the front of your foot until the
casters are free.
2. Move the cantilever arm to the bottom position (end stop).
Place the spreader bar vertically and secure it with the
transport strap Velcro, as shown in the picture.
3. Remove the safety spindle (locking pin) from the bottom end
of the pole by gently pressing the button at the head of the
spindle. The safety spindle can now be removed easily.
WARNING: Risk of injury - Once the pole is
L
4.
unlocked, its own weight can cause considerable
downward forces to be exerted.
Pull out the standing position safety (traction screw) until the
pole is released and can be tilted. The pole can now be tilted
forwards.
Tip the pole as far as possible forward that its head end
comes to rest on the spreader bar.
15
Eagle 620, Eagle 625
2022-04
Installation and adjustment
EN
NL