Homelite F-3045 Manuel D'utilisation page 27

Trimmer/Brushcutter-17 lgs
GB
F D E
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Engine will not start:
Lever will not go into the
"COLD START" position:
Engine starts but will not
Engine does not reach full speed
and emits excessive smoke:
Engine starts, runs, and
accelerates but will not idle:
Blade continues to rotate
at idle speed:
30/09/03 17:00
I P NL S DK
English
POSSIBLE CAUSE
1. No spark.
2. No fuel.
3. Flooded engine.
4. Starter rope pulls harder
now than when new.
Throttle trigger is depressed.
Carburettor requires
adjustment
1. Check oil fuel mixture.
2. Air filter dirty.
3. Carburettor requires
adjustment.
Carburettor requires
adjustment
Carburettor requires
adjustment.
21
Page 21
N FIN GR H CZ
SOLUTION
1. Check spark. Remove sparking plug. Reattach the
sparking plug cap and lay sparking plug on metal
cylinder. Pull the starter rope and watch for spark at
sparking plug tip. If there is no spark,
repeat test with new sparking plug.
2. Push primer bulb until bulb is full of fuel. If bulb does
not fill, primary fuel delivery system is blocked.
Contact a service dealer. If primer bulb fills, engine
may be flooded (see next item).
3. Remove sparking plug, turn trimmer so sparking plug
hole is aimed at the ground.
Make sure lever is in the "WARM START" position
and pull starter cord 10 to 14 times. This will clear
excess fuel from engine. Clean and reinstall sparking
plug. With the throttle trigger fully depressed, pull
starter cord three times with lever at "WARM START"
position. If engine does not start, move choke lever to
"COLD START" and follow normal starting instructions
in "STARTING AND STOPPING" section. If engine still
fails to start, repeat procedure with a new sparking
plug.
4. Contact a service dealer.
Release throttle trigger. Refer to "Starting and
Stopping" earlier in this manual.
Turn "L" needle anticlockwise 1/16 turn. If "L" low
needle (76) cannot be turned anticlockwise; do not force
plastic limiter caps. Contact a service dealer (Fig. 27).
1. Use fresh fuel and the correct 2-cycle oil mix.
2. Clean air filter. Refer to "Replacing and Cleaning Air
Filter" earlier in this manual.
3. Turn "H" needle (77) clockwise 1/16 - 1/8 turn.
(Fig. 27).
Turn idle speed screw clockwise to increase idle
(Fig. 27).
Turn idle speed screw anticlockwise to reduce idle
speed (Fig .27). If after adjustment, blade continues
to rotate, return to an authorised service dealer
for repair.
RUS RO PL